PDFWAC 296-806-480
Saws and cutting heads.
Summary
If your specific machine or operation is not listed here, then be sure to follow any of the following requirements that apply:
(1) General requirements for all saws and cutting heads in this section.
(2) General requirements for all saws in this section.
(3) General requirements for all cutting heads in this section.
(4) "Requirements for all machines" found in this chapter, WAC 296-806-200 and 296-806-300.
Reference: | For requirements on hand-held tools, see Portable power tools, chapter 296-807 WAC. |
This section applies to fixed machines using saws or cutting heads that are used on any material.
Your responsibility:
To make sure machines using saws and cutting heads meet these requirements.
Requirements for this topic… | begin with this section: |
GENERAL REQUIREMENTS FOR ALL SAWS AND CUTTING HEADS | WAC 296-806-48002 |
SAWS | |
General Requirements for All Saws | WAC 296-806-48006 |
Requirements for All Circular Saws | WAC 296-806-48008 |
Requirements for Specific Circular Saws | WAC 296-806-48024 |
Requirements for Band Saws and Drag Saws | WAC 296-806-48042 |
CUTTING HEADS | |
General Requirements for All Cutting Heads | WAC 296-806-48046 |
BORING AND MORTISING MACHINES | WAC 296-806-48048 |
CHIPPER AND HOG MILLS | WAC 296-806-48050 |
JOINTERS | WAC 296-806-48056 |
MOLDING, STICKING AND MATCHING MACHINES | WAC 296-806-48062 |
PANEL RAISERS AND OTHER SIMILAR MACHINES | WAC 296-806-48064 |
PLANERS | WAC 296-806-48066 |
SHAPERS | WAC 296-806-48074 |
TENONING MACHINES | WAC 296-806-48076 |
VENEER MACHINERY | WAC 296-806-48080 |
SEWING MACHINES | WAC 296-806-48502 |